
Which cylinder is jerking — you can see it on the chart.
A “misfire” fault code only says that something is wrong. Rough run (Laufruhe) measures how unevenly each cylinder runs, separately: the control unit compares how evenly each cylinder drives the crankshaft. A cylinder that “jerks” stands out on the chart before it starts storing faults.
SC Diag collects this series for 30 seconds, draws it for each cylinder and adds the engine speed at every measurement. The reading is made only on a running engine — the app checks that itself.
The engine's whole history and what is happening now.
The engine control unit counts misfires for every cylinder since new. SC Diag reads these counters and shows them cylinder by cylinder, and during the reading it also counts the increase — that is, how many misfires occurred while the engine ran in front of you. Where the control unit provides them, the counters since the last reset are also read, split by engine operating mode.
One cylinder stands out
This typically points to a problem in the cylinder itself: an injector, a spark plug, a coil or compression. The chart and the counters help narrow down the diagnosis before anything is replaced.
The whole engine runs unevenly
It more often points to a shared problem: fuel pressure, an intake leak, the mixture. That is why SC Diag records the mixture adaptations and the pressures at the same time.
Conclusions in the report
You can send us the reading's log with one button. In the PDF report we point to the cylinder and the system we suspect, and suggest a repair plan.
The cause of jerking can vary — a chart does not replace inspection and measurements. The scope of the reading depends on the engine, the control unit and the software version of the car.
Four steps to the chart.
1. Plug in the adapter
ELM327 over Bluetooth or Wi-Fi, or a K+DCAN USB cable (E-series).
2. Choose the symptom
Cold engine, warm engine, “always” or a pre-purchase check.
3. Start the engine
The app asks you to start the engine and starts by itself when it sees the engine speed. Keep your foot off the throttle during the measurement.
4. Assess or send
See the chart, the counters and the faults, or send the encrypted log for analysis.
Rough run and misfires — questions.
It is a measurement of how unevenly each cylinder runs, made by the engine control unit from the variations of the crankshaft speed. It shows which cylinder runs worse than the others, even if it has not stored a fault yet.
Usually not. Generic OBD readers show codes and basic parameters. Rough run in this system requires talking to the engine control unit in its own protocol — which is how SC Diag works.
Yes. The app waits for the engine to be started, measures for 30 seconds and discards standstill data so that it does not give a false picture.
The counters since new are read for each cylinder, together with the increase counted by the app during the connection. It is a good way to see whether the problem is growing.
Find out which cylinder is jerking.
Download SC Diag, take a reading and see the rough run chart of your N43 or N53.
Download SC Diag