Language: PL EN DE FR
Case study · Coding after replacement

Steering rack coding after replacement on a BMW

Silesia Codemasters · Case studies · ~3 min read

After replacing the steering rack on a BMW with electric power steering (EPS), the mechanical work is not the whole job. A new or used rack has its own control unit, which has to be coded and matched to the car and then calibrated. Without that, the power steering may not work properly and entries will appear in the fault memory.

BMW steering wheel coding after replacement: the interior of a BMW with the doors open, a laptop with software on the driver's seat and a yellow ENET cable on the floor

BMW F-series steering rack coding after replacement: a laptop and an ENET cable in a car with the doors open.

We describe this in general terms, because the details depend on the model, year and equipment. We do not give procedure numbers: there is no single procedure common to all cars.

Why coding is needed after replacing the steering rack

In newer BMWs the power steering is electric, and its control unit communicates with other systems: the stability control units, the steering angle sensor and, depending on the equipment, driver assistance systems as well. When the rack is new or comes from another car, the control unit has to receive the data that is right for this car and “learn” which car it is working in.

That is why after a replacement we usually perform coding or matching of the control unit, followed by calibrations. The scope depends on the car: we read its configuration first and only then decide what is needed. We discuss similar principles in the article on BMW F30 and G20 coding.

What the work usually includes

The equipment is the same as for coding other functions: a laptop, an interface and an ENET cable, as you can see in the photo. The car should have a stable power supply for the duration of the work, which we point out because a voltage drop while a control unit is being matched is a common cause of trouble.

This is a safety system

The steering system decides whether the car goes where the driver wants it to. After repairing it you must not stop at “faults cleared”: it needs to be checked and set up correctly.

A few rules we stick to:

  1. We do not clear faults just to switch warning lights off if we have not understood their cause.
  2. After work on the steering system a check is required, and usually wheel alignment as well, carried out at a mechanical or tyre workshop. Alignment is set after steering components are replaced, and we are responsible for the electronic part.
  3. The order matters: first the replacement and mechanical setup, then coding and calibration, and a test drive last.
  4. If the steering feels worrying after the work, we do not carry on driving “to see” – we go back to diagnostics.

Other things in the car are also linked, for example the steering wheel and its equipment – see BMW F22 steering wheel retrofit and coding.

On-site in Silesia, remote support

We most often work on the move in Silesia (base: Ruda Śląska) or at the workshop where the car is being repaired. Remote coding is possible for some cars, but after a steering rack replacement you usually need a direct connection and calibration, so we agree the scope before the visit. You will find more about our services on the page about BMW coding in Silesia.

Frequently asked questions

Usually yes. The power steering control unit has to be matched to the car and calibrated. The scope depends on the model and equipment, which is why we read the configuration first.

No. It is a safety system, so after the work a check is required, and usually wheel alignment and a test drive as well.

When a steering rack is replaced you usually need a direct connection to the car and calibration, so we do it on site. We agree the scope before the visit.

No, similar principles apply to many BMWs with electric power steering, although the details differ between series and model years.

Replaced the steering rack on your BMW?

We will code and calibrate the control unit, then check communication in the car.

BMW coding

See also

New: SC Diag — BMW engine diagnostics on your phone and laptopAn Android app and a Windows program: reading BMW and MINI engine control units (97 control units, petrol and diesel). The log analysis and report are prepared by Silesia Codemasters.See the app →
f