The owner of this BMW F30 320d with the N47 engine first came to us for a power measurement. The reason was a suspected particulate filter problem: the car clearly was not driving the way it should. It ended with full diagnostics, getting the car back in order and, only at the very end, Stage 1, with a result of 205 hp and 443 Nm.
Diagnosis first, then the tune
Computer diagnostics and a dyno run confirmed the suspicion: the DPF really was restricting the car and had a considerable effect on the power produced. In that situation, loading a map makes no sense, because the control unit will not let the engine deliver what the map assumes anyway.
So we started with the technical side. We carried out the necessary service work and a full software update of the car to the latest I-Level. After that the car went back on the dyno to check whether the engine was now delivering what it should.
Stage 1: before and after
Only on a healthy car was it time for Stage 1. The result from our portable DynoPRO dyno:
- Before: 166 hp and 371 Nm
- After: 205 hp and 443 Nm
- Gain: +39 hp and +72 Nm
At the wheels the dyno measured 170 hp and 398 Nm. Maximum torque appears at around 2,600 rpm and maximum power at around 4,300 rpm.
We do not start with the tune. First you have to find the problem, bring the car to the right condition and only then make use of the engine's potential.
Scope of work
- Power measurement on a DynoPRO chassis dyno
- Full computer diagnostics, including the DPF system
- Service work and software update to the latest I-Level
- Control measurement after the service
- Stage 1 chip tuning and verification measurement
Completed: September 2026, Ruda Śląska. See this project on Facebook.
Is your BMW not driving the way it should?
We will measure the power, find the cause and only then talk about Stage 1.
BMW chip tuning Stage 1 / Stage 2