The X5 and X6 of this generation are large, heavy and richly equipped cars – which means the cost of a neglected component can be noticeably higher here than on smaller BMW models. The N63 V8 engine, fitted to the more powerful versions, has one of the best-known weak points in the history of recent BMW engines, one that sellers often prefer not to mention.
N63 V8 – an engine with a weak point worth knowing about in advance
What to look out for
- Connecting rod bearings – the best-known problem of this engine. Premature bearing wear shows up as a characteristic knock from the engine, especially on a cold start. BMW even covered this issue with an extended warranty in some markets.
- Timing chain guides – another checkpoint on this engine, as on other BMW V8s of the period.
- Valve stem seals – a typical cause of rising oil consumption with age.
- Additional water pump – used to cool the turbochargers, another possible point of failure on this highly stressed engine.
N57 – six-cylinder diesel
What to look out for
- Timing chain – a less dramatic problem than on the smaller N47, but still worth verifying, especially on earlier versions of the engine.
- EGR cooler – a leak leads to coolant mixing with the exhaust gases.
- Injectors and swirl flaps – the same checkpoints as on other BMW models with this engine.
Air suspension – the specifics of a large SUV
On versions with rear or full air suspension it is worth checking the operation of the compressor and the condition of the air springs. It is one of the more expensive components of this generation, and neglect shows up as an uneven body height or a noisy compressor trying to maintain pressure.
xDrive and the transfer case
It is also worth checking the fault history of the power distribution system and the condition of the viscous coupling – faults in this area can be expensive to repair and do not always give a clear symptom on a short test drive.
With the N63 engine, pre-purchase diagnostics matters especially – the knock of worn connecting rod bearings can be hard to judge unambiguously without proper equipment and experience, and the cost of repairing a V8 engine is on an entirely different scale from the smaller units.
Checklist before viewing an X5 E70 and X6 E71
- Transfer case. Jerking when pulling away and turning, 4x4 drive messages, a set of tyres with even wear.
- Air suspension. Even ride height after a night, no constant running of the compressor.
- V8 engine. Oil consumption and smoking after standing at idle.
- Damp in the cabin. Blocked panoramic roof drains lead to flooded electronic modules.
- Diesel. Cold running, intake tightness, condition of the particulate filter.
What diagnostics will show that a viewing cannot
We read faults in the drivetrain, suspension and engine, as well as the mileage stored in several control units. On a diesel we check the injector corrections and the condition of the particulate filter, on a petrol the adaptations and misfires. On cars advertised as "chipped", it is worth adding a dyno measurement. The result shows whether the power is really there and whether the curve looks healthy.
Frequently asked questions
It is one of the best-known problems of this engine – premature wear of the connecting rod bearings, which BMW even covered with an extended warranty in some markets. It is worth checking whether the car has already had the repair done, or at least a check of the bearing condition.
Not always, but it is one of the more expensive components of this generation and it is worth checking how it works before you buy – the compressor and air springs have a limited life, and the repair can be expensive.
Mainly the timing chain (a less dramatic problem than on the smaller N47, but still worth verifying), the EGR cooler, the injectors and the swirl flaps.
Got a particular X5 or X6 in mind?
We will check the connecting rod bearings, the suspension and xDrive before you pay.
Book pre-purchase diagnostics