The NOx catalytic converter is one of the most expensive parts of the N43/N53, so news of its wear understandably causes concern. Before deciding on replacement, though, it is worth checking whether the drop in efficiency comes from permanent ageing of the catalytic coating or from reversible sulfur poisoning – because these two scenarios call for a completely different approach.
What sulfur poisoning of the catalytic converter is
Sulfur compounds present in fuel and oil gradually deposit on the catalytic surface, blocking its ability to reduce nitrogen oxides. This is a chemically reversible phenomenon – unlike ageing, which is permanent degradation of the catalytic coating itself, and which no procedure can restore to its original condition.
What the desulfation procedure involves
Regeneration consists of raising the temperature of the exhaust gas flowing through the catalytic converter in a controlled way for a set time, which allows the deposited sulfur compounds to evaporate and be removed, restoring the catalytic surface's original working ability. The procedure is carried out using suitable diagnostic software and cannot be performed without dedicated equipment.
When desulfation makes sense and when it does not
- It makes sense when the problem is detected relatively early and the drop in catalytic converter efficiency is mainly due to sulfur poisoning, not ageing.
- It does not make sense when the catalytic converter has worked in a sulfur-poisoned state for a long time or its catalytic coating has already suffered permanent degradation – in that case regeneration will either fail or give only a temporary, partial improvement.
If the sulfur poisoning returns soon after regeneration, it is worth investigating the cause – it is often a matter of the quality of the fuel used or a driving style dominated by short trips, where the exhaust never reaches a temperature sufficient for the catalytic converter to clean itself naturally.
How we check it
We analyse the data on NOx reduction efficiency and the catalytic converter's operating history to assess whether regeneration has a real chance of success before we even decide on it. This helps avoid the situation where a customer pays for a procedure that would not solve the problem for long anyway.
What a desulfation session looks like in practice
Sulfur is held in the catalytic converter more persistently than nitrogen oxides, so removing it takes a higher temperature and a longer time. During desulfation the control unit raises the catalytic converter temperature and cyclically changes the mixture composition. This requires driving with a steady, elevated load, preferably outside town. The procedure will not start on its own for a driver who only makes short trips. A session can also be triggered from diagnostics, and the values before and after can then be compared.
How to reduce sulfur poisoning in everyday use
- Fill up at stations with a good reputation. The sulfur content of the fuel matters directly here.
- From time to time, take a longer drive at a steady speed.
- Do not put off repairing the NOx sensor. Without its reliable signal the control unit will not carry out catalytic converter regeneration correctly.
- Keep an eye on oil consumption. The additives contained in the oil also burden the catalytic converter.
We write about the other factors in the article what really damages the NOx catalytic converter.
Frequently asked questions
Sulfur poisoning is a reversible chemical phenomenon that in many cases can be undone with a regeneration procedure. Ageing is a permanent loss of the coating's catalytic ability that no procedure can restore – replacement is necessary here.
Not always. Success depends on how long the catalytic converter has worked in a sulfur-poisoned state and how much of its catalytic surface has been blocked. The earlier the procedure is carried out, the greater the chance of full restoration.
Sulfur poisoning usually returns if its original cause (for example fuel quality, or a driving style with frequent short trips) is not changed. Regular, cyclical desulfation without addressing the cause can merely postpone the problem.
By analysing diagnostic data on NOx reduction efficiency and comparing it with the catalytic converter's operating history. Only such a picture lets you judge whether regeneration has a real chance of success or whether replacement will be necessary anyway.
Suspect sulfur poisoning of your NOx catalytic converter?
We will check whether regeneration makes sense before you commit to an expensive replacement.
Book an engine diagnostic